*****************************************************************************

*                                                                           *

*                      PCI 10/100Mb Fast Ethernet Adapter                   *

*                                                                           *

*                  NDIS2 Driver for Lan Server DOS Workstations             *

*                                                                           *

*                                                                           *

*****************************************************************************



Introduction:

=============



  The Ethernet NDIS2 Driver for Lan Requester DOS workstations confirms to the

  Network Driver Interface Specification(NDIS2). This document shows you how

  to setup the driver and how to use the enhanced functions by setting the

  custom keywords in configuration file.





Contents of the Subdirectory:

=============================



    FETND.DOS           The NDIS2 driver for Lan Requester DOS workstations.

    OEMSETUP.INF        The installation information file.

    LSDOS.TXT           This file.





Installation:

=============



  Before starting with the installation process, make sure that the adapter

  is properly installed and configured. You can use the diagnostic program

  (A:\SETUP.EXE) to make sure your connection with the network is correct.



  Installing driver procedure on DOS LAN Requester :

  -------------------------------------------------

      1) Install DOS Lan Requester to HardDisk with "NO Network Adapter

         Selected" option.



      2) Copy FETND.DOS from your Driver diskette to DOS LAN Services

         subdirectory, like C:\NET .



      3) Under DOS LAN Requester subdirectory C:\NET, run INSTALL



      4) Move highlight to "The listed options are correct" item ,

         then press ENTER.



      5) Move highlight to "Network Card", then press ENTER.



      6) Select "Change driver for network card." item, then press ENTER.



      7) Select "Network card not shown in list below..", then press ENTER.



      8) Insert the PCI Fast Ethernet driver diskette in floppy A,and specify

         the pathname A:\LANSVR40.DOS,then press ENTER.



      9) PCI Ethernet NDIS2 driver is now installed on your computer, reboot

         your computer.





Configuration Files:

====================



    Sample of configuration file:

    -----------------------------

    (Suppose the Lan Requester package is installed at C:\NET directory)



    File Name:          C:\CONFIG.SYS

    ----------

        DEVICE=C:\NET\PROTMAN.DOS /I:C:\NET

        DEVICE=C:\NET\DLSHELP.SYS

        DEVICE=C:\NET\FETND.DOS



    File Name:          C:\AUTOEXEC.BAT

    ----------

        SHARE

        C:\NET\NET START

        C:\NET\NET START PEER

        C:\NET\NET SHARE ZZZ=C:\



    File Name:          C:\NET\PROTOCOL.INI

    ----------

        ...

        # The followings are Custom Keywords. Put the keywords to enable the

        # special functions.

        [MS$FETND]

        DriverName=FETND$

       

        [IBM$NETBEUI]

        DriverName=netbeui$

        SESSIONS=20

        NCBS=20

        BINDINGS=MS$FETND

        LANABASE=0

        ...





    Custom Keywords:

    ----------------

        FULLDUPLEX                      This keyword is used to enable full

                                        duplex mode.



        SPEED                           This keyword is used to force the

                                        adapter at 10Mbps or 100Mbps speed.



        AUTO                            This keyword is used to force the

                                        chip at Auto-Negotiation mode.