Deskpro 4000s

Configuring System Board


System Board Illustration

Item Description Item Description
J1 Diskette Drive Connector (34 Pin) SW1 Processor Speed Switches
P20 Primary IDE Connector (40 Pin) P17 Power Supply Connector
P21 LS-120 Connector (40 Pin) P15 AUI Connector*
P25 CD-ROM Connector (50 Pin)** J4 Riser Board Socket
J11 Audio Connector J7 DIMM Socket
P16 Power Cable and LED Connector J8 DIMM Socket
P14 External Battery, Clear CMOS jumpers U26 Processor Socket
Note:
*The AUI connector on the back of the unit connects to the system board via a cable.
All other external connectors are integrated onto the system board.

** The CD ROM connector is specific to the Deskpro 4000s only. 
This 50 pin connector is not an IDE connector, but a proprietary connector in which the power to the drive is ran in the same cable.

Top of Page

Switches

  
Switch SW1
Password Control
Processor Speed*
S1 S2 S3 S4 S5 S6 Processor Speed
On -Disable Password On On Off On Off 166-MHz
Off -Enable Password Off On Off On Off 200-MHz
  Off Off Off On Off 233-MHz
  *66 MHz bus speed.
Do not configure the system board to operate faster than the speed at which the processor is rated. Doing this could result in unreliable operation or processor damage.
Top of Page

Jumpers

  
Jumper P14
External Battery Connector
Clear CMOS
Top of Page


This page was updated on June 02, 2002
Comments about this page
Privacy and Legal Statement