IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Before You Begin - Notes

1.  You do not need to turn the server off to install or  replace hot-swap power supplies, hot-swap drives,  hot-swap fans, or hot-plug PCI adapters.
2.  The color orange on components or labels in the  Netfinity 5500 indicates hot-plug components.
   •  Become familiar with the safety procedures, see 'Safety Information'.
   •  Make sure that you have an adequate number of  properly grounded electrical outlets for the server,  monitor, and any other options that you intend to  install.
   •  Place the server in a location that is dry. Rain or  spilled liquids might damage the server.
   •  Leave about 50 mm (2 inches) of ventilated space on  the right and left sides of the server to allow the  server cooling system to work properly. Leave 100  mm (4 inches) of clearance at the rear of the server  for cables.
   •  Have a supply of 1 MB and 2 MB, 3.5-inch diskettes  available.
   •  Back up all important data before you make changes  to disk drives.
   •  Have a small, flat-blade screwdriver available.
   •  For a list of supported options for the Netfinity 5500,  refer to http://www.pc.ibm.com/us/compat on the  World Wide Web.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.