Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Power Supply Removal



Power Supply Removal
 

Removing the power supply CRU:
  1.  Power-off the power supply CRU.
  2.  Disconnect the power cord from the power supply CRU.
  3.  Pull the pull ring lever up to unlatch the CRU.
  4.  Pull the CRU out of the controller unit.


Installing the power supply CRU:
  1.  Install the new power supply CRU into the controller unit.
  2.  The lever will snap down when the CRU is seated properly in the chassis.  If the lever remains up, push on the power supply CRU until the lever snaps into place.
  3.  Connect the power cord, power-on the controller unit and check all LEDs.

More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.