Return to MAIN-Index  Return to SUB-Index    IBM-AUSTRIA - PC-HW-Support    30 Aug 1999

Starting the RAID Configuration Program



Starting the RAID Configuration Program

You can run the IBM RAID configuration Program fom Diskette  or from the ServerGuide CD . It will be autom. invoked from the ServerGuide CD if the disk array has never been partitioned and if there is no user data present. However, updatet configuration information must be written to diskette . If you have not yet created the IBM SCSI-2 Fast/Wide Streaming-RAID Adapter/A Option Diskette (RAID controller diskette), go to 'Using the CD-ROM Drive and ServerGuide'

To start the RAID configuration program:

Insert the IBM SCSI-2 Fast/Wide PCI-Bus Adapter Configuration Option Diskette into the primary diskette drive and power-on the system. If the system already is powered-on, press Ctrl+Alt+Del. From the PC DOS start-up menu, select Start RAID Configuration Program, then press Enter.

If you have more than one RAID adapter installed, you will get an adapter selection screen similar to the following, otherwise, the Main Menu appears.

NOTE:
  1.  The version numbers and slot numbers on the screens might be  different.
  2.  The primary diskette drive is the first diskette drive that the  system tries to  start from.

 

You can select Help from any menu. To return to the previous screen or to the previous work area of a screen, press Esc. To select a menu item, press the number of the item or use the Up Arrow (  ) key or Down Arrow (  ) key to highlight the item, then press Enter.
 

The Main Menu contains the following choices:


Back to  Jump to TOP-of-PAGE
More INFORMATION / HELP is available at the  IBM-HelpCenter

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.